Equipment Chalk Chalkline Checklist Gather materials Chalk line Chalk Measuring tape Straight edge Prepare the surface Clean and dry the surface Determine the line placement Measure and mark the line placement lightly with chalk Load the chalk line Open the chalk line and fill it with chalk powder Set the line Place one end of the chalk line at one end of the line you want to mark and secure it Hold the other end of the line taut and perpendicular to the ground Snap the line

SOP Gather the necessary materials and equipment: Paint curbing machine or paint sprayer Paint suitable for curbing Curbing templates (if applicable) Measuring tape or ruler Stencils (if desired) Masking tape or painter’s tape Personal protective equipment (PPE) including gloves, goggles, and a mask Prepare the work area: Ensure the parking lot is clean and free from debris. Use masking tape or painter’s tape to mark the boundaries of the curbing area, if needed.

SOP: Cleaning/Changing Gun Filter Objectivebjective: To perform preventive maintenance and troubleshoot issues related to a thinning spray pattern or clogging in the Titan 3500 parking lot striping machine’s RX80 spray gun. Tools and Materials Required: Titan 3500 parking lot striping machine RX80 spray gun Lacquer thinner or cleaning solvent Cleaning brush or soft cloth Procedure: Identify the Issue: If To perform preventive maintenance and troubleshoot issues reexperiencing a thinning spray pattern or consistent line width issues, suspect a potential clog or dirty filter in the RX80 spray gun.

Images SOP Gather the necessary materials and equipment: 3/8" plywood or 1/4" louan sheets Aerosol traffic black paint Plywood or similar material for creating frames Chalk or temporary marking tool Personal protective equipment (PPE) including gloves, goggles, and a mask Prepare the work area: Ensure you have a well-ventilated space or work outdoors. Set up a work table or area with sufficient space to accommodate the size and quantity of black boxes you need to create.

SOP for visiting a site. Initial Contact: Upon receiving a request for a quote or inquiry from a potential client, acknowledge the request and express interest in visiting the site to assess the scope of the project. Schedule a Site Visit: Coordinate with the client to schedule a convenient time for the site visit. Consider factors such as the client’s availability and any specific requirements related to accessing the site. Prepare for the Site Visit: Familiarize yourself with the location and any available information about the project.

Painting the Stencil: Position the spray gun to only paint the stencil Ensure the paint sprayed evenly on the surface. Operating the Machine: Ensure the paint sprayed evenly on the surface. Cleanup: Clean the paint gun and machine thoroughly according to the manufacturer’s instructions. Safety and Final Checks: Ensure the painted area is cordoned off until the paint is completely dry. Verify the circle is evenly painted and meets the required specifications.

Painting the Circle: Position the machine at the starting point of the circle’s circumference. Align the back of the machine (where the paint gun is located) with the chalk line. Ensure the machine is level and stable. Operating the Machine: Start the machine and engage the paint gun. Begin moving the machine forward, following the chalk line carefully. Maintain a steady speed to ensure an even application of paint. Continuously check the alignment of the paint gun with the chalk line.

How to shake WATER-based pale of paint Introduction: This guide will demonstrate the correct method for stirring paint to avoid issues such as air bubbles and uneven color distribution. Step-by-Step Instructions: Preparation: Ensure you have all necessary equipment: paint can, stirrer, protective gloves, and a suitable surface to work on. Opening the Paint Can: Carefully open the lid of the paint can. If the can has been previously opened, watch for dry flakes that might fall into the fresh paint.